PVC Adhesive

PVC Adhesive is used for onsite joining of pieces of PVC pond liner. It can be used for joining liner where a waterfall or stream meets the main body of the pond.

PVC Adhesive is applied directly to the surfaces of the liners to be joined, and the following instructions should be followed when using it:

1. Both surfaces to be joined should be clean, dry and clear of dust or grease (if the surfaces require cleaning, water or detergent should be gently applied to remove any debris then the liner left to fully dry prior to joining).
2. Lay the top liner over the bottom liner.
3. Flap the top liner back on itself.
4. Apply PVC adhesive to the top of the bottom liner and bottom of the top liner to create a strip from the edge of the liner.
5. Leave the PVC Adhesive to dry for around 10 minutes until it is tacky.
6. Flap the top liner back over the bottom liner ensuring the two strips of glue line up.
7. Roll over the seam with a roller to make sure there is an even, secure bond between the liners.